A and H Models  
   
 

  Home > Lenz Digital Products > Useful Accessories from other manufacturers


ImageCodeNameDescriptionPriceQty 
LDT GBM-8-G 8-Fold Track Occupancy Detector
LDTGBM8LDT GBM-8-G 8-Fold Track Occupancy Detector

LDT GBM-8-G 8-Fold Track Occupancy Detector  DCC Control In Stock

If you use the Roco-Digital-System together with the Interface 10785 and the Software Rocomotion, you can use the track occupancy detector GBM-8 as an extension of the Roco Feedbackmodule 10787 to receive a comfortable and low-cost track occupancy report system.

There are no more switch-rails 42518  required. You simply isolate one rail at the track section to be monitored and connect this section with one of the 8 inputs of the track occupancy detector GBM-8.

The monitored track section will receive digital current via the 8-fold occupancy detector GBM-8.  As soon as a current consumer (loco or a wheel set with resistance lacquer) will be within the monitored track section the GBM-8 will report the occupancy situation to the Roco Feedbackmodule 10787.

The GBM-8 recognizes currents from 0,001 Ampere. The maximum digital current on each output can be up to 3 Ampere (peak current up to 7 Ampere).

The GBM-8 requires no separate voltage supply. Therefore is a minimum of wiring required.

The 8-fold track occupancy detector GBM-8 is devided into two 4-fold track occupancy detectors. Therefore is it possible to monitor tracks of two different booster sections. The partioning into two 4-fold track occupancy detectors simplifys the monitoring of  terminal loops as well.

£41.50
62000A LocoNet Cable Tester
UH62000A62000A LocoNet Cable Tester

Uhlenbrock 62000 LocoNet Cable Tester

  • Recognises short circuits
  • Tests for continuity
  • Recognises crossed cables
  • Testing of single or multiple cables
  • Identify New and Old LocoNet cables (On old LocoNet the cables are reversed)
  • Can also be used for XpressNet and other cables that have RJ11, RJ12 and RJ45 plugs

Contains Cable tester, protective pouch, 9V battery

£9.95
LDT DSU Permanent power switch unit
LDTDSULDT DSU Permanent power switch unit

LDT DSU Permanent power switch unit  DCC Control In Stock

Used to switch polarity on the turntable bridge to allow lights and sounds to remain running as the table turns

£9.50
LDT LS DEC BR G Colour light signal decoder
LDT LS DEC BR GLDT LS DEC BR G Colour light signal decoder

LDT LS DEC BR G Colour light signal decoder in a case for BRITISH RAIL Signals  DCC Control In Stock

For the first time is it possible to switch train light-signals with our LS-DEC light-signal decoder directly by using the decoder addresses. Ideal for Memory- (IB-switch) and PC-control. No further circuitry required. The signal wiring will be simply connected to the signal module with practical and secure clamps.

Up to two 7-aspect signals (advance- and main-signal on one common signal post) or four 2-aspect signals (e.g. block- or shunting signals) or two 3-aspect signals (e.g. main-signals) and two 2-aspect signals can be controlled by one light-signal decoder LS-DEC.

£51.75
LDT M-DEC-DC-F  Decoder for DC Point motors
LDT M-DEC-DC-FLDT M-DEC-DC-F Decoder for DC Point motors

LDT M-DEC-DC-F  Decoder for DC Point motors  DCC Control In Stock

£44.10


 
 Return to main site View Cart