Lenz LW150 Mimic Panel Module
Setting Addresses:
-35952-p.png)
Set the XpressNet address to avoid conflicting instructions from several XpressNet Devices (The unit is set on 4 from the factory):
-35952-p.png)
DIP switch 8 on block 1
By setting Dip switch 8 you can effect how the LW150 behaves on start up of the layout.
Dip Switch 8 On - The LW150 will send switching commands so that the points will correspond to the track diagram (Works setting)
Dip Switch 8 Off - The LW150 does not automatically send switching commands on start up power. If a point is incorrect on the diagramm then its indicator lights will flash prompting you to change the point to the correct direction (Only use this setting if you have indicator LEDs connected)
By setting Dip switch 8 you can effect how the LW150 behaves on start up of the layout.
Dip Switch 8 On - The LW150 will send switching commands so that the points will correspond to the track diagram (Works setting)
Dip Switch 8 Off - The LW150 does not automatically send switching commands on start up power. If a point is incorrect on the diagramm then its indicator lights will flash prompting you to change the point to the correct direction (Only use this setting if you have indicator LEDs connected)
View
Showing 1 - 4 of 4 products
Showing 1 - 4 of 4 products
